FMG的凝固、脱模和固化时间是什么？
Set time is the time when the slurry loses workability and begins to stiffen and set - also referred to as working time. Using a typical alpha product formulated for this process, set time will be 20-30 minutes. Set time can be shortened with accelerators or lengthened with retarders. Without acceleration, parts made with FGR-95 are normally demolded after 60-90 minutes. While the parts may be strong enough for demolding in 60-90 minutes, they will not have fully cured and will still be "green". This is an ideal time to do any finishing or chasing of edges. A demolded part will begin drying immediately after removal from the mold. The rate and degree of final curing will be dependent on ambient weather conditions. Hot/dry will cure faster than cold/wet. In typical conditions of temperature and relative humidity, full cure can take 5 to 7 days. For larger pieces such as architectural moldings, orientation or support of the piece while curing is very important. All gypsum based materials are subject to cold creep. If the pieces are not stored properly while curing, warping or bowing might be cured into the piece.
免责声明
这些FAQ文章作为参考,并提供模具制造和浇注过程中遇到问题的可能解决方案。由最终用户确定任何特定应用的适用性。我们不做保证。使用任何材料前参考所提供的技术公告(TB)和安全数据表(SDS)。在大范围使用前，建议小范围试验确定任何建议的适用性。