Dragon Skin® FX‑ Pro
注：产品包装可能有所不同
特征
- 质地柔软：邵氏硬度为2A，使用较少的SLACKER软化剂就能制作出更柔软的用具
- 低粘度：结合较长的操作时间，减少气泡产生，使浇注更加容易
- 固化后干燥：固化过程中不会渗出硅油
- 操作时间长：10 - 12分钟的操作时间，适合较大规模的浇注或注射作业
- 固化速度快：40分钟的固化时间，能够快速完成浇注件或模具的制作
- 易操作性强：具备 “凝胶” 阶段，材料倒入假肢模具中更加轻松，提高了工作效率
说明
Measuring & Mixing
Before you begin, pre-mix Part B thoroughly. After dispensing required amounts of Parts A and B into mixing container (1A:1B by volume or weight), mix thoroughly making sure that you scrape the sides and bottom of the mixing container several times.
Pouring
For best results, pour your mixture in a single spot at the lowest point of the containment field. Let the rubber seek its own level. A uniform flow will help minimize entrapped air. If using as a mold material, the liquid rubber should level off at least 1/2” (1.3 cm) over the highest point of the model surface.
Curing
Allow rubber to cure for 45 minutes at room temperature (73°F / 23°C) before demolding. Time to demold can be reduced with mild heat or by adding an appropriate amount of Plat-Cat® cure accelerator (See Plat-Cat® technical bulletin available at www.smooth-on.com for details). The pot life and cure times can be extended using Slo-Jo® cure retarder (see Slo-Jo® technical bulletin available at www.smooth-on.com for details). Do not cure rubber where temperature is less than 65°F / 18°C.